3.3. Order of installation of the piston of the 1st cylinder in compression step VMT.
1. On a pulley of the crankshaft the mark for exposure of the piston 1 - го the cylinder is provided in compression step VMT.
2. Installation of the piston (or pistons) in VMT of a step of compression is an integral part of many procedures.
3. Transfer the check point lever to neutral situation. Disconnect a high-voltage wire of the coil of ignition from the central conclusion of a cover of the distributor and connect to weight on the block of cylinders.
4. Uncover the distributor and find on a cover the provision of a high-voltage wire of a candle 1 - го the cylinder. If this conclusion is not numbered, then determine it by a wire from a spark plug.
5. Turn the crankshaft a key or a starter so that the mark in a pulley was combined with a tag About on a scale. The normal direction of rotation of the engine - clockwise (photo).
5. If the runner indicates the tag put on the distributor case, then the piston 1 - го the cylinder is in compression step VMT. Otherwise tighten the crankshaft on one whole revolution clockwise (360 °) and install the piston of the 1st cylinder in compression step VMT.
6. Now it is possible to expose in VMT of a step of compression and other pistons, turning the crankshaft on 180 ° and observing an operating procedure of cylinders.