3.12. A head of cylinders - removal
1. Merge cooling liquid.
2. Remove the air filter.
3. Remove the pump of the hydraulic booster and a roller of a natyazhitel of a belt of the pump (if are provided).
4. Disconnect from candles of a wire and take aside together with arms.
5. Disconnect an air ejection tube, remove the valve case (if it is provided).
6. Remove the soaking-up collector.
7. Remove the thermal vacuum distributor with an arm from a partition of a motor compartment.
8. Disconnect a recirculation tube.
9. Remove the fuel pump (mechanical).
10. Remove a final collector.
11. Uncover a head of cylinders.
12. Install the piston of the 1st cylinder in VMT of a step of compression and remove a cam-shaft asterisk (see above).
13. Release 10 bolts of a head of cylinders, turning off each bolt on 1/4 turn at one time. Release bolts in the specified sequence (photo). Turn out bolts and you store in cash desk in that order in which they were wrapped.
14. Turn off two small bolts of fastening of a forward cover.
15. Displace a head, easy blows through a wooden pro-rate and remove.
16. Remove laying.
17. The technique of check of a head is described in Part C.