3.16. A crankshaft pulley - removal and installation
1. Disconnect the battery from weight.
2. Remove a radiator with a casing.
|
15.4 Check of a gap in gearing of gear wheels (1), a gap between the conducted gear wheel and a pump housing (2), an axial side play (3) and deformation of the plane of the case (4)
|
3. Remove the lower forward cover.
4. Take off belts.
5. Turn off a pulley bolt, having included transfer or having recorded a flywheel (on the car with automatic transmission).
6. Remove a pulley by means of a stripper (photo).
7. Installation is carried out upside-down. Oil a pulley opening for the engine. Tighten all bolts with the set moments.