f0647bde

4.16. The oil pallet - removal and installation

1. Disconnect the battery from weight.
15.86 Measurement of diameter of an opening in a yoke.


15:6í... and openings under a pusher in the case I


15:8á Diameter of the roller is measured in the location of a yoke


2. Lift a forward part of the car and establish on supports.
3. Remove a guard of a case and merge oil.
4. Remove a starter.
5. Remove brackets of fastening of a bell-shaped case to the engine.
6. Remove the pendular lever.
7. On cars 4x2 remove stability stabilizer arms.
8. On cars 4x2 remove a stretcher.
9. On cars 4x4 remove an arm передня a reducer.
16.17a Apply sealant to places of a prileganiye of the holder of a back epiploon and the oil pump  

16.17b Places of putting sealant on laying of the pallet
1. Laying

17:3á Bolts of the oil pump


10. Remove transmission support.
11. Disconnect exhaust pipes from collectors.
12. You will hang out the power unit on a waist or establish under it a jack.
13. Turn off bolts of fastening of support of the engine to a frame.
14. Raise the engine a little, being careful.
15. Turn off bolts and remove the pallet.
16. Carefully clear the demountable planes of the block of cylinders and the pallet of the consolidation remains. Banish and clear carving openings in the block of cylinders.
17. Apply sealant (photo) on the demountable planes.
18. Install laying on the pallet, install the pallet and evenly in a cross order tighten bolts with the set moment (photo).