4.3. Order of installation of the piston of the 1st cylinder in compression step VMT.
1. For installation of the piston of the 1st cylinder in compression step VMT on a pulley of the crankshaft the corresponding marks are provided.
2. Apply a tag under a conclusion of a wire of a candle of the 1st cylinder on the case of the distributor.
3. Uncover the distributor.
4. Turn the crankshaft so that the mark in a pulley was combined with the index (photo).
5. If the runner indicates the tag put on the distributor case, then the piston 1 - го the cylinder is in compression step VMT. Otherwise tighten the crankshaft on one whole revolution clockwise (360 °) and install the piston 1 - го the cylinder in compression step VMT.
6. Now it is possible to expose in VMT of a step of compression and other pistons, turning the crankshaft on 120 ° and observing an operating procedure of cylinders.