7.12. The case of a butterfly valve (for systems with preliminary injection of TBI of systems) removal and installation
Removal
1. Execute a decompression and disconnect the battery from weight.
2. Merge about 1 l of liquid.
3. Remove the air filter.
4. Disconnect from draft of a butterfly valve a cable of the drive of the gate and a cable круизконтроля (photo).
5. Disconnect hoses of the regulator of pressure and a dilator of bystry idling, turn off 4 nuts and remove the case with laying.
|
10.22a the Arrangement of units system of injection with preliminary preparation of gas mixture on the V6 1 engine. Tank (station wagon) 2. Tank (truck) 3. Seat of the assistant 4. Exhaust pipe 5. Sensor of exhaust gases 6. A tank with an absorber 7. C
|
|
10.22b the Arrangement of units system of injection with preliminary preparation of gas mixture on 4 cylinder engine 1. Seat of the assistant 2. Emergency relay 3. Details of system of injection: Stream speed sensor Sensor of turn of the gate Switch хо
|
Installation
6. Installation is carried out upside-down. Check correctness of connection of all cables, hoses and sockets.
7. Start the engine and be convinced of lack of a leak of fuel about nozzles. Check idling turns. Warm up the engine and add liquid.