f0647bde

13.4. Half shafts - removal and installation

1. Lift the car and establish on supports.
2. Remove a wheel.
3. Remove the automatic interlock device.
4. Get a lock ring from a half shaft pin.

2. З Details of the device of an automatic interlock 1. Lock-nut of a nave 2. Lock washer 3,8. Spring ring 4. Washer 5. Lead B 6. Washer A 7. Washer B 9. Lead A 10. Spring 11. Sealing ring 12. Case 13. * we Grease automatic interlock device details


2.4 After removal of the case get a lock ring, washers and a lead B 1. Lead B 2. Lock ring 3. Washer And


3.6 Apply tags on the case of the sliding hinge and on the reducer case then turn off bolts


5. Remove a washer and a lead of Century.
6. Turn off bolts of fastening of a half shaft to a reducer (photo).
7. Turn off the lower bolt of the shock-absorber.
8. Remove a support (Hl. 10), take aside and fix.
9. Disconnect steering draft.
10. Slightly you will hang out the lower lever a jack. Turn off nuts and bolts and disconnect spherical support of levers. Carefully remove a half shaft assembled with a rotary fist.
11. Beat out a half shaft from a fist (photo).
12. At detection of defects on details sort a half shaft (see below).
13. Installation is carried out upside-down. Check an axial side play of a half shaft (photo). If the side play exceeds norm, then pick up a lock ring for thickness (see Specifications).