f0647bde

13:10. A forward reducer - removal and installation

1. Lift a front of the car and establish on supports.
2. Merge oil from a reducer.

10.2 Designate position of the driveshaft concerning a flange of the transfer case


10. 5 Carter and epiploons of the transfer case
1. Tube of a sapun
2. Secret cap 
3,8,10. Epiploon
4. Stopper of a filling opening
5. Drain stopper
6.11. Case section
7. Forward cover
9. Sensor of the alarm system of inclusion of the forward bridge


11:5á Sockets of wires on the transfer case


3. Disconnect the forward driveshaft from a reducer.
4. Turn off bolts of fastening of half shafts to a reducer, displace half shafts and fix by a wire, without allowing sagging on CV JOINTS.
5. Prop up a reducer a support.
6. Turn off bolts of fastening of a reducer (photo).
7. Turn off bolts of support of the engine and you will hang out the engine.
8. Turn off bolts of fastening of a reducer to a frame (photo).
9. Carefully lower a support and get a reducer.
10. Installation is carried out upside-down.