8.12. Starter replacement of brushes
Starter without reducer
1. Remove a starter and the traction relay.
2. Remove a back sealant (photo).
|
11:2í Starter Details (without reducer) rear wheel drive cars with 4 cylinder engine 1. Traction relay 2. Anchor 3. Sealant 4. Lock washer 5. Persistent washer 6. Back cover 7. Back plug 8. Brush holder 9. Brush () 10. Brush (+) 11. Yoke
|
|
11:2ó Starter Details (without reducer) all-wheel drive cars with 4 cylinder engine 1. Adjusting laying (thickness of 0,5 or 0,8 mm) 2. Traction relay 3. Back cover 4. Yoke 5. Winding of excitement 6. Brush (+) 7. Anchor 8. Brush holder 9. Рыч
|
|
11:9á Starter Details (with a reducer) cars with 4 cylinder engine 1. Traction relay 2. Adjusting laying (sealant) 3. Spring 4. Lever 5. Forward cover 6. Case of a reducer 7. Laying 8. Leading gear wheel 9,18. Ring 10. Anchor 11. About
|
|
11:9í Starter Details (with reducers) cars with the V6 1 engine. Traction relay 2. Orbital gear wheel 3. Back cover 4. Sealant 5. Bolt 6. Anchor 7. Yoke 8. Partition 9. Washers 10. Brush holder 11. Planetary gear wheels 12. Leading gear wheel 13. Ш
|
3. Get a lock ring and a persistent washer.
4. On a back cover unscrew two screws of the brush holder.
5. Turn out coupling bolts and remove a back cover.
6. Get the brush holder (photo), take away springs and get brushes. If height of brushes is less than 12 mm, then unsolder them and solder new.
7. Collect a starter upside-down.
Starter with a reducer
8. Remove a starter and the traction relay.
9. Turn out coupling bolts (photo).
10. Remove a back cover, without having damaged a ring.
11. Separate from a cover a yoke assembled with an anchor and the brush holder.
12. Take away springs and get brushes from the brush holder (photo), unsolder and solder new (if height of brushes less norm).
13. Collect a starter upside-down.