f0647bde

5.13. The block of cylinders - cleaning

Attention!
If caps of channels of the cooling system fail to the canal of the block of cylinders, then it is impossible to take them, as a rule.

1. Drill in caps of an opening and pull out, having wrapped bolts or self-tapping screws, or get a stripper with the bent pads.
2. Carefully clear the block of the remains of consolidation (photo).
3. Uncover radical bearings and get bearings from the block of cylinders and covers. Designate all details that not to mix them.
4. Clean all channels a vapor jet and compressed air (it is recommended to carry out in car service), wash out the block outside detergent. Banish all carving openings, clean and blow compressed air (photo). Dry the block and oil the processed surfaces veretenny.
12.3 Removal of covers on 4 - cylinder engines


13.4 Pro-race of a carving opening


5. Establish covers of radical bearings, tighten bolts by hand.
13.6 Cap press fitting


14:2á Measure diameter of the cylinder under fillets (A), in the center (V) and in the lower part (C)


14:2ó Measurement of diameter of the cylinder


14:3á The Brush for a honningovaniye of cylinders


14:2í The Telescopic nutromer for measurement of internal diameter


6. Press new caps without distortions, previously having greased them with RTV sealant (photo).