15:14. A wheel - removal and installation
Attention.
Cars of 1996 are equipped with a safety cushion which is in a container in the center of a steering wheel. When working near inertial sensors, a steering column, the dashboard disconnect from the battery of a wire and wait not less than 10 min.
1. Disconnect the battery from weight.
2. Remove or disconnect a container with a safety cushion (if it is provided), having addressed to car service.
3. On cars till 1994 unscrew 2 screws from the back of a wheel (photo), on cars since 1994 of release remove the panel of a sound signal for what unscrew the cross screw-driver screws in the lower part of spokes and remove a collar.
4. Make sure that the wheel is unblocked and turn off a wheel nut.
5. Designate the provision of a wheel concerning a shaft (photo).
6. Vypressuyte a steering wheel, having wrapped stripper bolts in the special openings provided ы to a wheel nave on both parties of a shaft (photo). It is forbidden to remove a wheel blows to a nave.
7. Before installation grease the back rubbing part of a wheel (photo).
8. Installation is carried out upside-down. Combine the put tags, tighten a nut with the set moment and check freedom of rotation of a wheel.