f0647bde

14.4. A brake support - removal, dismantling and installation

Attention!
The described operations belong to brakes, the equipped both one-piston and block (two-piston) cylinders.

1. Remove blocks.
2. Unscrew the hose union on a support (photo), disconnect and muffle a hose.
3. Turn off the top bolt of a support and remove a support from a disk.
4. Clear a support, following safety rules.
5. Carefully remove pistons with compressed air (photo), previously having wound the cylinder with rags.
2. 2a Disk тоомоз CL25VA (rear-wheel cars with 4-cylinder engines) 1. Copper laying 2. Cylinder 3. Cuff 4. Piston 5. Cover 6. External laying 7. Blocks 8. Holders 9. Support 10. Finger. To grease the sliding part 11. Caps 12. Вн

2.2v Bolte of the lower axis


2.3 Tilting of a support for access to blocks 1. Cylinder 2. Block 3. Holders


2.2b the Disk brake of CL25VD (all all-wheel drive cars and all cars with V6 engines) 1. Hose 2. Cap 3. The union for pumping 4. Cylinder 5. Cuffs 6. Piston 7. Cover 8. External laying 9,17. Block 10. Holders 11. Support 12. On sites соприкасающ

2.5 Lubricant points silicone structure 1. Place of lubricant


2.7 Support shift for installation of external laying


2.8 Lubricant of holders of blocks 1. Place of lubricant


3.5 Removal of the piston from the cylinder compressed air


3.6 Extraction of a cuff 1. Support 2. A flute in the cylinder 3. Cuff 4. Plastic tweezers


3.2 Turn off a bolt and disconnect the union. Copper laying is subject to replacement


6. Carefully get a cuff (photo) from the cylinder.
7. Turn out the union for pumping, get fingers and covers from a support.
8. Wash out and dry details.
9. Check a condition of pistons and the internal surface of the cylinder. At detection of noticeable damages, wear of a covering of a detail replace. At detection of corrosion on bolts replace bolts.
10. At assembly grease the piston and the cylinder with brake fluid, establish a new cuff (photo).
11. Dress a cover on the piston, having laid in a flute (photo).
12. Enter the piston into the cylinder without distortions, then having pressed drown the piston against the stop in a bottom of the cylinder (photo).
13. Install a cover on the cylinder.
14. Wrap the union for pumping
15. Grease fingers with silicone lubricant and establish with new covers in a support.
16. Further operations are carried out upside-down. Remove air from a hydraulic actuator of the understanding brake.
3.10 Installation of a cuff 1. Support 2. Cuff 3. Flute


3.11 Installation of a cover on the piston


4.3. Brake disk surface