14:19. Cables of the emergency brake - removal and installation
Forward cable
1. Release the brake lever.
2. Disconnect a cable from the lever (photo).
3. If necessary lift a back part of the car and establish on supports.
4. Turn off a nut and disconnect the opposite end of a cable from the leveling lever (on all-wheel drive cars) or from the regulator (on rear-wheel cars).
5. Disconnect a back left cable from forward.
6. Turn off bolts of the leveling lever.
7. Disconnect all collars and remove a forward cable and the leveling lever.
8. Installation is carried out upside-down. Grease all rubbing details.
|
18.2 Details of the drive of the emergency brake of the car "Terrano I/Pathfinder" 1. Back cable 2. Regulator 3. Forward cable
|
Back cable
9. Release the brake lever.
10. Turn off a nut and disconnect a cable from the leveling lever (on all-wheel drive cars) or from the regulator (on rear-wheel cars).
11. Disconnect a back left cable from forward.
12. Disconnect tips of a back cable from back brakes and get tips through openings in a brake board.
13. Weaken collars and remove cables.
14. Installation is carried out upside-down. Grease all rubbing details.